Tab Content
  • Darrenmb's Avatar
    02-20-2020, 03:23 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Oops, missed a question in your response, yes I tested white wire and had pulses while opti was off, and yes I checked for ground on c. You can see...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-20-2020, 03:21 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    You are following along well. Lol. I did take note of the acdb thing, noting the letters on the actual connector not the picture.. I will check the...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-20-2020, 02:31 PM
    I have issues.. well the car, not me... I am sure i have issues too, but this isn't the place to discuss them.. lol She wont start!! Working...
    5 replies | 1278 view(s)
  • Darrenmb's Avatar
    02-20-2020, 02:12 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    That is what I am saying, however, when opti is not installed and spun by hand, i get 8, 4-5 volt spikes on the white wire per revolution and...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-20-2020, 07:18 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    I did, I get the voltage when spinning opti by hand but cannot see it when ots on motor and using starter, tried with two multimeter, you still...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-19-2020, 08:07 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    I have to be missing something.... new icm and coil, still no spark... think I need to double check my harness, something has to be awry somewhere...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-15-2020, 10:39 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Ok, I'm at a bit of a loss now, hooked up opti and spun by hand , fuel pump runs, Injectors clicking away... guess my multimeter just doesnt refresh...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-14-2020, 06:43 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Thanks, glad you mentioned that or I would not have!
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-13-2020, 08:53 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Thanks, I pulled off the opti, so that test should be easy enough.
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-13-2020, 05:37 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Ok, it looks like all signs point to the opti, but before I pull it off, I have one more question.. The 4 wires to the opti, I have 5 volts 5...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-13-2020, 09:53 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Didnt get home until late last night, got a few mins to do some tests before I ran out of daylight, its currently looking like the opti or its...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 12:41 PM
    5 replies | 1293 view(s)
  • Darrenmb's Avatar
    02-12-2020, 12:39 PM
    5 replies | 1293 view(s)
  • Darrenmb's Avatar
    02-12-2020, 11:34 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    I am at work scanning shoeboxes site, and have yet another question... the dark blue wire that is labeled fuel enable thatbis supposed to be hooked...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 10:01 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    I simply brought the purple starter solenoid wire from the 4 wire black connector inside, back out and plugged onto existing jag starter relay. Do i...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 09:17 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Opti is 1st gen but was converted to vented by opticdoc. Had no movement at all from tach, and yes I had to add a resistor and its tied into pcm...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 09:16 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    I have no codes at all, (per scan94/95) , didnt get to check for spark as it was getting dark and I had no helper, that's on tonights checklist....
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 08:03 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Additionally I am reading a vats issue, but pcm was tuned by Moe Bailey, supposed to have deleted vats, but I don't know how to double check that..
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 07:21 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Kept hitting back and my post was still there that way, so copied and pasted, sorry if it's a duplicate now
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 07:20 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Sorry, guess I said it wrong, I dont actually get an ses right, then ight comes on for bulb test when ignition is first turned on. I have hooked up...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 07:19 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Wow, my whole post is gone again... looks like the edit issue I am.having is actually deleting...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-12-2020, 07:17 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Ok, having issues with editing above post for spelling and autocorrect issues keeps telling me invalid page.. but whack is supposed to say eehack ...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-11-2020, 07:50 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Just an update, ground was fine, was the 12 switched ( pink wire ) was bad, had 12 volts, about an inch away from the connector and 2.7 volts at...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-11-2020, 10:35 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    My post dissapeared... oh well, thank you guys, I know that wire is hooked up as it's one if last ones i did, however I put it on an Oil pan bolt...
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-11-2020, 06:15 AM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    Sorry, everything is from a 94 pontiac formula
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-10-2020, 05:48 PM
    Darrenmb replied to a thread Pcm ground in Tuning and PCM
    I see the ground wires by the coil.. is that all of them? Just two whites tied together and a black???
    39 replies | 439 view(s)
  • Darrenmb's Avatar
    02-10-2020, 05:46 PM
    Darrenmb started a thread Pcm ground in Tuning and PCM
    Still working on my swap into the jag, thought I was ready to try to start it, turned key on, no fuel pump prime and no check engine light, I have...
    39 replies | 439 view(s)
More Activity
About Darrenmb

Basic Information

About Darrenmb
Name:
DARREN BRANDON
Vehicle:
1983 jaguar xj6

Statistics


Total Posts
Total Posts
36
Posts Per Day
0.12
General Information
Last Activity
Yesterday 07:49 AM
Join Date
05-01-2019
Referrals
0
No results to display...
No results to display...
iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback For Darrenmb
View Complete Feedbacks for Darrenmb
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0