Tab Content
  • Injuneer's Avatar
    08-02-2020, 12:33 PM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    Remove the IAC and see if the pintle looks crudded up. If it is, try cleaning it with brake cleaner and a Q-tip. That isn't going to damage it. ...
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-28-2020, 07:00 PM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    If you plan to clean the IAC valve, do not attempt to move the pintle. You will damage the valve. Also, do not spray cleaner on anything other than...
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-24-2020, 02:30 PM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    When you turn the steering wheel, the PCM should open up the idle air control valve (IAC) to maintain the target (1,000) RPM. Could be an IAC...
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-24-2020, 01:47 PM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    If it's idling rough, try lightly misting the ignition wires with water, in the dark, to see if it causes any arcing. Check for vacuum leaks using...
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-24-2020, 01:42 PM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    meissen I think this would get more responses if it was in "LTx Engine Tech"
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-24-2020, 11:03 AM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    How long has it been doing this? When was the pcmforless tune done? Have you scanned it for codes since you replaced the O2 sensors? Do you know...
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-22-2020, 02:34 PM
    There are two switches on the clutch pedal bracket: - Cruise Release Clutch Switch - open with clutch pedal depressed (pink wire on terminal B,...
    493 replies | 24356 view(s)
  • Injuneer's Avatar
    07-15-2020, 10:14 AM
    If the wires get wet, or coated with any fluids at the entrance to the sensor body, it can screw up the sensor readings. Ambient air has to reach...
    5 replies | 133 view(s)
  • Injuneer's Avatar
    07-13-2020, 02:47 PM
    Sticking with the stock 10-bolt rear is questionable with that kind of HP, and a T56 drivetrain.
    5 replies | 150 view(s)
  • Injuneer's Avatar
    07-13-2020, 02:40 PM
    Injuneer replied to a thread 02 sensor in LTx Engine Tech
    "PCM BAT", not PCM IGN. Should clear in 30 seconds. I think they put the PCM BAT fuse back in the instrument panel box in 1996.
    17 replies | 420 view(s)
  • Injuneer's Avatar
    07-07-2020, 05:04 PM
    Shoebox shows: 1994-1995 heated oxygen sensor AC-Delco # AFS75 GM 19178930 Check the wiring harness first to make sure there isn't a short to...
    5 replies | 133 view(s)
No More Results

7 Visitor Messages

  1. Will do. Not sure if my response got "Sent"... I'll be there at 7:00pm. My cell is 732-894-0442
  2. View Conversation
    Call or text me anytime tommorrow anytime. 732-547-3245
  3. View Conversation
    Does tues night at 7pm at Champs in the Menlo Mall work for you?
  4. Let me know when.
  5. View Conversation
    I will set this up for 1 day next week. I just have to make sure my wife will be home to take care of my son.
  6. I'm ready.... just about any evening after 6:00pm, or a Saturday or Sunday. I can give George the CD of all his 30th SS photos that he asked me for about 3 years ago.

    Still working for Earle, and they are slave drivers...... 11 hours a day during the week, and a 1/2-day most Saturdays. I have no time for anything. Maybe one of you would enjoy owning a 94 Formula.
  7. View Conversation
    Hey i talked to George today and he said that he would like to get together for some bugers and beers like old times. So Basically when is a good time for you? Im just about always available.
Showing Visitor Messages 1 to 7 of 7
About Injuneer

Basic Information

About Injuneer
Biography:
Card carrying member - NHRA and AARP
Location:
Central NJ
Vehicle:
1994 Formula
Occupation:
Licensed Professional Engineer (Mechanical)

Signature



94 Formula A3+1: 381ci forged stroker - Callies Stealth, Oliver 5.85 billet rods, BME nitrous pistons / CNC LT4 heads / Comp Cams solid roller / TH400+GearVendors OD / 4.11's/Strange 12-bolt / 300-shot (dry) N2O / Spohn Suspension / 6-pt roll bar /AutoMeter instrumentation / MoTeC M48 Pro engine management system /a few other odds 'n ends.

Statistics


Total Posts
Total Posts
2,030
Posts Per Day
0.76
Visitor Messages
Total Messages
7
Most Recent Message
04-30-2013 05:10 AM
General Information
Last Activity
Yesterday 11:50 PM
Join Date
04-21-2013
Referrals
4

2 Friends

  1. atufo1475 Offline

    InActive Member

    atufo1475
  2. Tinbender59 Offline

    InActive Member

    Tinbender59
Showing Friends 1 to 2 of 2
Page 1 of 9 12345 ... LastLast

07-24-2020


06-15-2020


05-02-2020


05-01-2020


04-20-2020


03-26-2020


11-30-2019


11-20-2019


11-18-2019



Page 1 of 9 12345 ... LastLast
No results to display...
iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback For Injuneer
View Complete Feedbacks for Injuneer
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0