• Navigation
  • Facebook

  • Recent Forum Posts

    DeuceSS

    P0300 all cylinders

    Does the OBD2 pcm stop reporting misifes with MAF unplugged?

    MAF grms/sec drop to 2.46 (from ~10 plugged in) --no misfires. Cleaned MAF twice--MAF wiring checks out ok. Should i be looking overly...

    DeuceSS Yesterday, 08:51 AM Go to last post
    Injuneer

    Remove the IAC and see if the pintle looks...

    Remove the IAC and see if the pintle looks crudded up. If it is, try cleaning it with brake cleaner and a Q-tip. That isn't going to damage it. Just don't spray the brake cleaner toward the inside...

    Injuneer 08-02-2020, 12:33 PM Go to last post
    Brandon++S

    So. I'm getting 53ohms according to the test , so...

    So. I'm getting 53ohms according to the test , so electrical checks out. Should I remove it and clean or is there a way to leave it in and clean. Don't want to mess the pintle or anything up by...

    Brandon++S 08-01-2020, 05:05 PM Go to last post
    LDM

    LDM's 383 nitrous stroker build

    Well I found a good shop local in my area that still does LT1 work and got the stripped block dropped off this morning. They are going to start checking it and verify it will work for my build, so...

    LDM 07-31-2020, 12:08 PM Go to last post
    Brandon++S

    Ok. Thanks Sent from my SM-G930V using...

    Ok. Thanks

    Sent from my SM-G930V using Tapatalk

    Brandon++S 07-28-2020, 07:49 PM Go to last post
    Injuneer

    If you plan to clean the IAC valve, do not...

    If you plan to clean the IAC valve, do not attempt to move the pintle. You will damage the valve. Also, do not spray cleaner on anything other than the pintle. Hold the valve with the pintle...

    Injuneer 07-28-2020, 07:00 PM Go to last post
    Brandon++S

    Ok. Will test and clean then report back. Not...

    Ok. Will test and clean then report back. Not going to be the cause of stumbling though correct? I'm guessing I have 2 problems going on?

    Sent from my SM-G930V using Tapatalk

    Brandon++S 07-28-2020, 06:45 PM Go to last post
    harner

    Now THAT is the TL;DR version that should have...

    Now THAT is the TL;DR version that should have made it to the top of the article!

    harner 07-28-2020, 08:27 AM Go to last post
  • Google Ads